1986F150Six

https://www.ebay.com/itm/1985-1986-85-86-Ford-Bronco-Dash-Harness-XLT-AC-FUSEBOX-OEM/174154147116?hash=item288c65652c:g:fqwAAOSwKfZeG9~b

Expensive! https://www.ebay.com/itm/1980-1986-80-86-Ford-Bronco-XLT-Moulding-Trim-COMPLETE-SET-OEM/133371892797?hash=item1f0d95943d:g:z4AAAOSwD39efTzv

https://www.ebay.com/itm/80-86-1980-1986-Ford-Truck-Bronco-Dash-Defrost-Vent-Duct/133076267394?hash=item1efbf6b182:g:lLUAAOSwRJZc-UsW

https://www.ebay.com/itm/80-86-Ford-Truck-Bronco-door-power-window-Wiring-Harness-Switches-Regulators/174154162965?hash=item288c65a315:g:GhwAAOSwej9eG-f9

https://www.ebay.com/itm/80-86-1980-1986-Ford-Truck-Bronco-Dash-Defrost-Vent-Ductwork-For-AC/174227518264?hash=item2890c4f338:g:dY8AAOSwuhZed0nm

https://www.ebay.com/itm/1980-1986-Ford-F150-F250-truck-BRONCO-Red-windshield-pillar-trim-80-86/333572059506?hash=item4daa71b172:g:T44AAOSwygFefDHv

Welcome, Chris!

Looking good!

https://www.ebay.com/itm/80-86-1980-1986-Ford-truck-Bronco-Fuse-Box-Fusebox-With-Bracket-Cover-OEM/133320273356?hash=item1f0a81edcc:g:~ZsAAOSwiGReMsST

Welcome, Jason! Oceans Springs is about as far south as you can go, in MS.

Welcome to the forum!

Welcome!

I need to clarify my comments a bit, because we're probably on the same page. I'm also running 275/60/15 Copper Cobras all around, but our roads are worse than yours, and with the ruts in the asphalt, the wide 60's series tires track with the ruts badly...so on that kind of road (which we have a lot of) the steering wanders quite a bit. When I was running the truck with the stock small tires, it wasn't nearly as bad. My old man's Infiniti and my wife's Lexus are the same...winter tires no problem. Throw the low pro summer tires and wheels back on, and they're tracking all over the place. On smooth flat asphalt, they all track straight and smooth. The tighter RedHead box eliminated a lot of the wander, but the truck still tracks with the road (ruts) a bit. If I threw a set of 235/75/15's on it, it would probably drive perfectly. Mine handles corners pretty well. One thing with those Ford steering boxes is that most of the slop is when driving straight. Throw them into a turn, and that is where the boxes are still nice and tight. We have some pretty twisty roads around here, and I must say, my steering is solid while turning. Driving straight down the road though...it still does wander a little bit. Yes I do remember them having some bump steer going on that did improve with smaller tires, at one point I was even running 7.0-15 bias plys. I have looked into a redhead/bluetop box as well but that truck isn't worth putting that money into anymore. Every truck I've ever had wandered in a straight line, eventually I just got so used to it that driving a brand new car made me drive all over the road. I run stock sized [215/75 X 15] tires and have found that by running about 3 PSI less in the rear, the truck handles and rides the best. Normally, I set the tires @ 35 PSI in front and 32 PSI in back.

https://www.ebay.com/itm/NOS-1980-Ford-Truck-Glove-Box-Liner-Insert-No-A-C-F150-F250-F350-/202757753682

https://www.ebay.com/itm/1980-1986-Ford-F100-F150-F250-F350-Pickup-Upper-Dash-Pad-Assy-Genuine-OEM-Red/143579807167?hash=item216e05fdbf:g:OH0AAOSwlplelMI4

https://www.ebay.com/itm/NOS-1983-1986-FORD-F150-F250-F350-XLT-PASSENGER-SIDE-DOOR-SWITCH-BEZEL-GREY/361902826402?hash=item544316e3a2:g:90cAAOxyCSRSHXXj

https://www.ebay.com/itm/NEW-OEM-Ford-E0TZ-7100-B-Transfer-Case-Shift-Collar-Hub-1980-1991-Warner-Gear/202964711017?epid=1023786857&hash=item2f41a3b669:g:hqgAAOSwP2ZelNzM

https://www.ebay.com/itm/NOS-1980-1989-Ford-Bronco-Steering-Column-Tube-Flange-E0TZ-3790-A/373021252506?epid=1423530574&hash=item56d9cc9b9a:g:FNEAAOSwqUtejOaA

https://www.ebay.com/itm/NOS-OEM-Ford-1980-1986-Truck-Bronco-Cowl-Grille-1981-1982-1983-1984-1985-F150/124153909786?hash=item1ce826521a:g:SaEAAOSwKgxeliB~

https://www.ebay.com/itm/NOS-84-85-86-Ford-Bronco-F-U100-350-Dash-to-Engine-Ground-Cable-E4TZ-14303-A/362968933448?hash=item5482a26448:g:hGYAAOSwTAhek530

https://www.ebay.com/itm/BW1345-FORD-SPEEDOMETER-DRIVE-GEAR-6-TEETH-WITH-STEEL-SLEEVE-1-375-ID-2-OD/164157783733?hash=item263890feb5:g:UfoAAOSwItFekgd2

I have always thought that you are well grounded, Gary!

Nice!

Well done! Welcome to the forum!

Beautiful truck!