Jump to content
Bullnose Forum

Frogger2662

Regular Members
 View Profile  See their activity

  • Posts

    227

  • Joined

  • Last visited

  • Days Won

    1

Frogger2662 last won the day on September 24 2024

Frogger2662 had the most liked content!

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Frogger2662's Achievements

Community Regular

Community Regular (8/14)

  • Dedicated Rare
  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done

Recent Badges

7

Reputation

  1. Frogger2662
    That one is good. The wire pulled out of one of the other connectors.
  2. Frogger2662 started following Standalone E4OD Controllers? Input Needed , Open barrel connectors and Cowl vent to hood seal
  3. Frogger2662
    I am replacing the wiring going from my wiper switch to my wiper motor. I want to replace the individual open barrel connectors on the switch and the motor. The ones on the motor are a retangular connector about 1/4x5/16 in size. What are these called and where to get them.
  4. Frogger2662
    Thanks. I missed that in my search.
  5. Frogger2662
    Going to replace my cowl vent to hood seal. Looking at using the garage door seal. Does anybody have any pics of there upraded seals for me to look at before I start. Any opinions or anything to look for while doing the install.
  6. Frogger2662
    I see now. The pic i was looking at showed the screen. It is extra. My bad.
  7. Frogger2662
    Understand your concerns. The screen comes with it at that price.
  8. Frogger2662
    https://www.efisystempro.com/sniper-transmission-control-kit-551-101-102-103#tab-specification After reading this article it looks to me you can completely dissconect the display if you choose. It is used for initial setup and to moniter trans if desired. They have versions for carbs are sniper efi. With a carb you will need to have a throttle postion sensor.
  9. Frogger2662
    The way I understand it after reading the Holley instructions is the screen is used to set up the program. You no longer need to use the screen unless you want to make changes to your setup.
  10. Frogger2662
  11. Frogger2662
    Holley is now selling a stand alone trans controller for carb or efi. Looks like it comes with the 3.5 screen also. Do not know how the price compares to ohter options.
  12. Frogger2662
    Correct. The hole in the ring is about 1/8 of an inch bigger than the filler neck. The actual peice you remove to fill the tank is seled with an o-ring. Push in on the center section and give it small twist. It then pops up and you can unscrew it.
  13. Frogger2662
    I centered the tank and not the filler neck. Going to move the tank over when i redo my bed floor. The tank can mve to either side by a couple of inches.
  14. Frogger2662
    I will try and get some pics of the filler neck tomorrow.
  15. Frogger2662
    The fill cap is a push in and twist style. As of now just a simple hole thru the bed. Filler neck is just below flush. Vent with rollover valve extends over the frame rail and mounts in the fender well above filler neck level.
  16. Frogger2662
    The next pic is how I have the filler set up on the tank. Do not have any pics of the bed floor with the gas cap.
×
×
  • Create New...