Bullnose Enthusiasts Forum › Marketplace › eBay, Craigslist, Facebook, & Kijiji Finds

4500 RPM tachometer - used

Classic

List

Threaded

16 messages Options

1986F150Six

4500 RPM tachometer - used

Administrator

Advertisement is labeled as being for Diesel, but the 4500 RPM tach was for gas engines and I used one in a F150 with 4.9L engine.

https://www.ebay.com/itm/125910820992?epid=1786871364&hash=item1d50dea880:g:7nAAAOSwnDFkTa-4&amdata=enc%3AAQAIAAAA4DvSO%2Fnmmol08aApgH9abaxvtenxUS68SM085XpHdFNTDB5jMLeQvvhFGEGCboimaAuV89qeQ5PEm4sDj95I%2Bm%2BPZHr8cjBoZFFRGSA8gMX%2BBLIA%2FAp6%2F%2FRvFmmN%2FV%2BeiitrPPsv1%2FUE5GZYnURz5Y%2Ffo%2B%2FsU%2B%2F7VgCmLjEdh%2BV3L3QRig3v%2BoXRfJxsVw1msfQlAhdGmL96bX8zpq1QNyDeKgmJ8fyPlQIuElLYjspnYS4%2Fuvp3hfk8%2FbhhZCzqoKLY1fc0NI0lVOuReSzVsKNdaT8n6r3qZFTp9vKuh%2BWQ%7Ctkp%3ABk9SR9ClmfyDYg

81-F150-Explorer

Re: 4500 RPM tachometer - used

That is definitely a medium duty F-600/900 instrument cluster circa 1992-1999, due to the electronic speedometer head.

Everything should work with our pickups except for the speedometer.

Truck: 1981 F-150 Explorer / Engine: 300-6 California MCU Feedback System / Trans: T-18 - 4 speed / 2.75 Ford Rear Axle Open Diff.

Tarheel Blue

Re: 4500 RPM tachometer - used

Can anyone tell from the back view if the cluster came out of a diesel as claimed in the ad or could it be from a gas F 600/900?

Kurt K
'85 XLT Lariat, 4.9L, NP435, 3.08LS, DSII, 130a 3G, PMGR, '87 MC, P235/R75

81-F150-Explorer

Re: 4500 RPM tachometer - used

This post was updated on .

It's from a gas powered medium duty truck. Circa 1992/1999 F-600/900. You can tell that from the speedometer head being electric.

The diesel tach had the words diesel fuel only written on them during this time frame. 1992/1999.

The Gasoline tachs came in 40 x100, 45 x100, and for our pickups 60 x100.

The Diesels were 45 x100 with a redline at 35x100 for our pickups..

Edited to correct an error in bold.

Sorry I didn't catch that earlier.

Truck: 1981 F-150 Explorer / Engine: 300-6 California MCU Feedback System / Trans: T-18 - 4 speed / 2.75 Ford Rear Axle Open Diff.

Tarheel Blue

Re: 4500 RPM tachometer - used

Thanks, that was my suspicion. I have a question into the seller to please verify whether gas or diesel. Says he’ll check when back in town.
If it turns out to be gas, it’s gonna be mine. 😏

Kurt K
'85 XLT Lariat, 4.9L, NP435, 3.08LS, DSII, 130a 3G, PMGR, '87 MC, P235/R75

1986F150Six

Re: 4500 RPM tachometer - used

Administrator

On the back of the tachometer where the 4 terminals are, the Diesel will have a + or - for the signal, where the gas will be battery and signal [coil].

A 4500 RPM tach with E0TF-17B316-B is a gas tach, but may be either open or enclosed

https://www.garysgaragemahal.com/uploads/6/5/8/7/65879365/4242524_orig.jpg

https://www.garysgaragemahal.com/uploads/6/5/8/7/65879365/1477349_orig.jpg

Tarheel Blue

Re: 4500 RPM tachometer - used

This is what the back of my yellow/red 4500 diesel tach looks like. And it has the # E5TF-17B316-A on its face.

Hoping I can get a pic of the back of the tach in the listing from the seller sometime this weekend.

Kurt K
'85 XLT Lariat, 4.9L, NP435, 3.08LS, DSII, 130a 3G, PMGR, '87 MC, P235/R75

BigBrother-84

Re: 4500 RPM tachometer - used

In reply to this post by 1986F150Six

Boy!
I realize I was lucky, finding a complete cluster w/tripometer and tach.
Paid it around 30$ USD at my local yard, 5 years ago.

Jeff / 1984 F350 Crew Cab 4x4/5.8L w351 4V/ T18/ D50 4.10 front/ 8' bed.
Restored 2019-2022.
Nicknamed «Big Brother 1984», due to its soooo-looong shape & nod to George Orwell's 1984 famous novel.

Tarheel Blue

Re: 4500 RPM tachometer - used

Found this locally, it is missing the post that is grounded if installing for an 8 cyl, but I’d be using for a 6 cyl. Think it would work? Or should I pass? Is there any way to field test without installing on a running engine?

Kurt K
'85 XLT Lariat, 4.9L, NP435, 3.08LS, DSII, 130a 3G, PMGR, '87 MC, P235/R75

Gary Lewis

Re: 4500 RPM tachometer - used

Administrator

A bit concerned that the tach is sitting at 1300 R's with no input. So it may be stuck or way out of calibration. If the latter you can pull the needle off and put it back on at 0.

But you can test by installing three jumpers:

Power: The lower right connector is B+ and that goes to 12v

Ground: The upper right connector is ground

Ignition: The upper left connector is for the signal in and it goes to the low side of the coil, which is labeled Tach and will be DG/Y wire.

Here's what some of the tachs say on the back:

Gary, AKA "Gary fellow": Profile

Dad's: '81 F150 Ranger XLT 4x4: Down for restomod: Full-roller "stroked 351M" w/Trick Flow heads & intake, EEC-V SEFI/E4OD/3.50 gears w/Kevlar clutches
Blue: 2015 F150 Platinum 4x4 SuperCrew wearing Blue Jeans & sporting a 3.5L EB & Max Tow
Big Blue: 1985 F250HD 4x4: 460/ZF5/3.55's, D60 w/Ox locker & 10.25 Sterling/Trutrac, Blue Top & Borgeson, & EEC-V MAF/SEFI

Tarheel Blue

Re: 4500 RPM tachometer - used

Thanks Gary. It didn’t even register with me that the needle is sitting @ 1300.
To be clear, I’d still need to have a running engine to connect the jumpers to, or is there a way to simulate the DG/Y tach signal?

Kurt K
'85 XLT Lariat, 4.9L, NP435, 3.08LS, DSII, 130a 3G, PMGR, '87 MC, P235/R75

Gary Lewis

Re: 4500 RPM tachometer - used

Administrator

Yes, the engine has to be running. But there is a chance you could simulate a running engine by connecting the signal wire to positive/disconnecting/connecting RAPIDLY. That will only provide 12v instead of the much higher voltage that the coil creates, something like 50v if I remember correctly, but it might work.

Gary, AKA "Gary fellow": Profile

81-F150-Explorer

Re: 4500 RPM tachometer - used

It might only make the tach needle jump though instead of read anything.

Truck: 1981 F-150 Explorer / Engine: 300-6 California MCU Feedback System / Trans: T-18 - 4 speed / 2.75 Ford Rear Axle Open Diff.

Tarheel Blue

Re: 4500 RPM tachometer - used

Ha! At my age there are very few things that I can do RAPIDLY!
Good to know for future reference, however I’m going to pass on this one. Too many ifs and buts, and you know what they say about candy and nuts!
The counter man says that he’s pretty sure he has a couple more trucks he can look at, it just might be a few days before he can shoot me some more pictures.
Fingers crossed.

Kurt K
'85 XLT Lariat, 4.9L, NP435, 3.08LS, DSII, 130a 3G, PMGR, '87 MC, P235/R75

1986F150Six

Re: 4500 RPM tachometer - used

Administrator

Another listing with a suspected bad tachometer, due to needle position:

https://www.ebay.com/itm/314602986191?epid=1786871364&hash=item493fcc9acf:g:a1UAAOSww4ZkaNmt&amdata=enc%3AAQAIAAAA0NxiE5GRaH5FWqc32xkPzYWiaBdCs%2BKAz%2FJ%2FdJ3hVPHin3i29ocMs%2BqnFfyLxvtqrptI3%2BKhgDGH7JaTkkExVRN9p7wA7YNE5p0b9w9hsfEA0TY5vL6gey6V69OBPVjlI1oargMYk2rAtCjxUZ3OxwyGdYboqiuhY%2FB25s1YEbLmu1bEKFollnfUjKzF0CVXA7eGl0jhC5J1ifgeiyjFq%2B7lZxsHAm7CpYMfIuwXXLucCOmKE%2B%2FFMz2FhLRAohhtjI8RZWCB0cHgrL84f1qO2%2Fs%3D%7Ctkp%3ABk9SR6CsiuWJYg

Tarheel Blue

Re: 4500 RPM tachometer - used

Sent seller a question about that issue.

Kurt K
'85 XLT Lariat, 4.9L, NP435, 3.08LS, DSII, 130a 3G, PMGR, '87 MC, P235/R75