PossumTruck Posted April 25, 2022 Share Posted April 25, 2022 I seem to have finally addressed water ingress into the truck and am now on to floor repair. Where the floor has rusted, the glued-on hard insulation chips off and/or can be scraped off. Where water didn't settle and cause rust, that stuff is really on there. Any tips on the best technique for removal? Or is it really just a use what ya' got and elbow-grease away. Was thinking wire attachment on my grinder. Link to comment Share on other sites More sharing options...
PossumTruck Posted April 26, 2022 Author Share Posted April 26, 2022 To add context, here is a photo from this weekend with some arrows to the stuff I'm talking about. I believe I was reinstalling the flywheel at the time, wife thought it looked funny. The passenger side pan shows a bunch that I have already removed. Fresh paint underneath. The rest is really on there. Link to comment Share on other sites More sharing options...
Gary Lewis Posted April 26, 2022 Share Posted April 26, 2022 I think your idea of a wire wheel is best. But I'd get as much off as I can with a scraper or somesuch before hitting it with the wire wheel just to keep the mess down as bits will fly everywhere. Link to comment Share on other sites More sharing options...
mat in tn Posted April 26, 2022 Share Posted April 26, 2022 I think your idea of a wire wheel is best. But I'd get as much off as I can with a scraper or somesuch before hitting it with the wire wheel just to keep the mess down as bits will fly everywhere. Dont be afraid of trying a dull putty knife and heat gun. Less flying bits and less damage to fix later. Follwed by min spirits or goo gone and a chore boy to get the crusty part. I also buy brillo pads by the jumbo box as i clean a ton of different parts the old fashioned way. Link to comment Share on other sites More sharing options...
CRittaler Posted April 30, 2022 Share Posted April 30, 2022 To add context, here is a photo from this weekend with some arrows to the stuff I'm talking about. I believe I was reinstalling the flywheel at the time, wife thought it looked funny. The passenger side pan shows a bunch that I have already removed. Fresh paint underneath. The rest is really on there. Common thing that is done in the Suzuki Samurai groups I'm in is to use dry ice to freeze it, it makes it brittle and can be air hammered off. Link to comment Share on other sites More sharing options...
FuzzFace2 Posted April 30, 2022 Share Posted April 30, 2022 Common thing that is done in the Suzuki Samurai groups I'm in is to use dry ice to freeze it, it makes it brittle and can be air hammered off. Thats what I was going to say dry ice and most of the time comes right off. Dave ---- Link to comment Share on other sites More sharing options...
Recommended Posts