Gary Lewis Posted November 15, 2021 Author Share Posted November 15, 2021 What sort of adapting did you have to do to make it fit? I know the question is for Frogger, and I'm interested in what he tells us. But I found that the tabs that hold the reservoir to the fender are about 1" farther apart than on the Bullnose reservoirs. So I had to make a whole new bracket for mine as I have it mounted on the passenger's fender. Link to comment Share on other sites More sharing options...
Frogger2662 Posted November 15, 2021 Share Posted November 15, 2021 What sort of adapting did you have to do to make it fit? It has been a couple of years since i installed it. Going by memory the top holes were further apart. Had to drill a new hole for the mounting location on the core support side. I used a 1/4-20 nutzert. There is a mounting tab on the bottom of the resoiver that had to have a small mod to. Do not remember what it was. Link to comment Share on other sites More sharing options...
Gary Lewis Posted November 15, 2021 Author Share Posted November 15, 2021 It has been a couple of years since i installed it. Going by memory the top holes were further apart. Had to drill a new hole for the mounting location on the core support side. I used a 1/4-20 nutzert. There is a mounting tab on the bottom of the resoiver that had to have a small mod to. Do not remember what it was. Since I have the '85 and '90 reservoirs I thought I'd get some pics and measurements. First, a view of the bottom with various things called out: Red ovals show where the pin/tab is that locates the reservoir on the bottom Green arrows show where the inlets are from the radiator Blue arrows show where the discharges are for the washer pump Next, an end view: Last, the measurements, and the one on the right shows the holes in the tabs are ~1" farther apart on the later reservoir: Link to comment Share on other sites More sharing options...
Recommended Posts