1bigD Posted September 7, 2021 Share Posted September 7, 2021 Hi there, I figured out what the numbers are in front of the color of wire on the electrical wiring diagrams once I saw the circuit list on the documentation site. The question I have is, what is the T/O in the splice code on the wiring diagram? ie "near T/O to the headlamp switch" Davin Link to comment Share on other sites More sharing options...
ArdWrknTrk Posted September 8, 2021 Share Posted September 8, 2021 I've only seen that in the EVTM, but I believe it means that the pressure welded splice is taped over in the harness. Link to comment Share on other sites More sharing options...
1bigD Posted September 8, 2021 Author Share Posted September 8, 2021 I've only seen that in the EVTM, but I believe it means that the pressure welded splice is taped over in the harness. Jim, thank you that makes sense now. Link to comment Share on other sites More sharing options...
85lebaront2 Posted September 8, 2021 Share Posted September 8, 2021 I've only seen that in the EVTM, but I believe it means that the pressure welded splice is taped over in the harness. Actually I believe it stands for "take out" where a harness branches. Link to comment Share on other sites More sharing options...
81f100custom Posted September 8, 2021 Share Posted September 8, 2021 Actually I believe it stands for "take out" where a harness branches. I did run across this at some point when I was wondering the same thing. Did not really say exactly what the T/O means unless like stated above. The abbreviation T/O is used in the component location section to indicate a point in which the wiring harness branches out to a component. Upon a little further digging I did find a document that stated what Bill said above exactly. Link to comment Share on other sites More sharing options...
ArdWrknTrk Posted September 8, 2021 Share Posted September 8, 2021 Actually I believe it stands for "take out" where a harness branches. Thank you for the correction! Link to comment Share on other sites More sharing options...
kramttocs Posted September 9, 2021 Share Posted September 9, 2021 Thank you for the correction! I thought it was Taped Over as well. Glad this question was asked Link to comment Share on other sites More sharing options...
Recommended Posts