Starliner Posted June 23, 2020 Share Posted June 23, 2020 As far as I can guess, to take the door glass out i will need to unbolt the regulator so i can get it to slip off the glides. Just figured i would check with the experts. I want to replace my glides and door seals. When I was a kid there were no how to videos, no forums, no help anywhere, we just DID. Now I am not as ambitious. Thanks Link to comment Share on other sites More sharing options...
kramttocs Posted June 24, 2020 Share Posted June 24, 2020 You don't have to unbolt the regulator but you do need to unbolt the front and rear tracks although the front won't move much. Then it's a matter or rolling up the window and tilting the window. There is a gap near the vent window you will utilize. I tape the door on either side to help protect it. Link to comment Share on other sites More sharing options...
Starliner Posted June 24, 2020 Author Share Posted June 24, 2020 You don't have to unbolt the regulator but you do need to unbolt the front and rear tracks although the front won't move much. Then it's a matter or rolling up the window and tilting the window. There is a gap near the vent window you will utilize. I tape the door on either side to help protect it. I hadnt thought of that. The glides/sliders though, they need to be drilled out to replace them so regulator has to come out either way I think. Link to comment Share on other sites More sharing options...
Gary Lewis Posted June 24, 2020 Share Posted June 24, 2020 I hadnt thought of that. The glides/sliders though, they need to be drilled out to replace them so regulator has to come out either way I think. Don't miss that we have the factory shop manual section on that here: Documentation/Body?FRONT DOOR WINDOW GLASS & MECHANISMS. Link to comment Share on other sites More sharing options...
Starliner Posted June 24, 2020 Author Share Posted June 24, 2020 Don't miss that we have the factory shop manual section on that here: Documentation/Body?FRONT DOOR WINDOW GLASS & MECHANISMS. Oh great. Why am I not surprised Gary. Link to comment Share on other sites More sharing options...
ArdWrknTrk Posted June 24, 2020 Share Posted June 24, 2020 You don't have to unbolt the regulator but you do need to unbolt the front and rear tracks although the front won't move much. Then it's a matter or rolling up the window and tilting the window. There is a gap near the vent window you will utilize. I tape the door on either side to help protect it. Scott, I never realized you would unbolt the front track from the vent window. I've always pulled out that whole assembly. But maybe that's why my bricknose has that different divider between the two. The '80-'86 vent window frames I see on U-techcenter seem to have the front window channel attached too. Link to comment Share on other sites More sharing options...
kramttocs Posted June 24, 2020 Share Posted June 24, 2020 Scott, I never realized you would unbolt the front track from the vent window. I've always pulled out that whole assembly. But maybe that's why my bricknose has that different divider between the two. The '80-'86 vent window frames I see on U-techcenter seem to have the front window channel attached too. Hey Jim, I wasn't clear on that part. The track remains attached to the vent window (all one piece) and stays in the door. You just remove the bolt from where the ear on the track attaches to the inner door. The rear track (that is just a straight piece of track) is the important one as it moves a lot more and gives you the ability to get the glass out of the tracks. Speaking of- pulling the vent window assembly would give you a little more room to get the glass out but isn't necessary and I wouldn't bother with it unless one needs to do work on the vent window itself. Link to comment Share on other sites More sharing options...
Recommended Posts