kramttocs Posted February 21, 2020 Share Posted February 21, 2020 Was reading up on these (40,000 1.5ohm) for the 460. Stock vs it comparison aside, if this was used would something need done with the wiring because of the resistor wiring between splice 401 and 216 (pretty sure those are the numbers - couldn't zoom in well on my phone)? Link to comment Share on other sites More sharing options...
ArdWrknTrk Posted February 22, 2020 Share Posted February 22, 2020 Well, it's slightly more resistance than the stock coil (1.17 ohm) but I don't see that it produces a higher voltage spark than stock. 1.5 ohm should be ok with a DSII module. Link to comment Share on other sites More sharing options...
kramttocs Posted February 22, 2020 Author Share Posted February 22, 2020 Well, it's slightly more resistance than the stock coil (1.17 ohm) but I don't see that it produces a higher voltage spark than stock. 1.5 ohm should be ok with a DSII module. Thanks Jim! I used one when I converted my ford tractor from points and it's been reliable. Good to know it's not that different from stock and is a direct replacement. Link to comment Share on other sites More sharing options...
Recommended Posts