HVAC - Air Conditioner Recirculating Air Duct - Diagram Item#19A813

[1986F150Six]

My blend door didn't need repair so I only had to deal with replacing the foam on 'flat' doors. I am not sure of a good solution to making new foam that has the same profile as this one. Open cell spray foam applied and then cut to form, maybe?

Gary - did you say you had to repair this one?

This may be a rabbit trail [slightly off topic], as it is not the part the original poster is looking for, but this information [mentioned some time back in another similar topic thread] may be helpful:

https://www.detroitmuscletechnologies.com/ford-80-86-pickup-truck-f150-f250-bronco-ac-heater-box-rebuild-seal-kit/?gclid=Cj0KCQjww4OMBhCUARIsAILndv4oP_9ulrPbrTJcmHioB4G8shZ2SfEEk5tsEIxl_ExHiW5TcCgoCZgaAncEEALw_wcB

[1986F150Six]

This may be a rabbit trail [slightly off topic], as it is not the part the original poster is looking for, but this information [mentioned some time back in another similar topic thread] may be helpful:

https://www.detroitmuscletechnologies.com/ford-80-86-pickup-truck-f150-f250-bronco-ac-heater-box-rebuild-seal-kit/?gclid=Cj0KCQjww4OMBhCUARIsAILndv4oP_9ulrPbrTJcmHioB4G8shZ2SfEEk5tsEIxl_ExHiW5TcCgoCZgaAncEEALw_wcB

If the blend door needs replacing, see if this helps:

https://shop.broncograveyard.com/1980-1986-Ford-Bronco-and-F-Series-Truck-Heater-Blend-Door/productinfo/37282/

[kramttocs]

If the blend door needs replacing, see if this helps:

https://shop.broncograveyard.com/1980-1986-Ford-Bronco-and-F-Series-Truck-Heater-Blend-Door/productinfo/37282/

Thanks David!

I forgot that JBG offered the door with new foam. Appears to slip on? Double sided tape inside perhaps? I don't see staples.

Note that they are calling that the 'blend' door instead of the 'panel' or commonly called 'vent' door.