Gary Lewis Posted August 21, 2020 Share Posted August 21, 2020 Dennis Carpenter sells parts made by others for many vehicles, including Bullnose trucks. If you've had dealings with them please rate them on customer service, pricing, quality, etc. And, if you'd like a review would be helpful. Link to comment Share on other sites More sharing options...
Littlebeefy Posted August 21, 2020 Share Posted August 21, 2020 IMHO Only the highest quality parts. Many of their parts are made with original Ford tooling. Sometimes not the cheapest, but I prefer to buy their version if it's made with original tooling (their website shows if the product was made using original tooling specifically). I have bought from DC as well as JBG, LMC, and NPD, so I have some comparative experience and that is why I prefer DC for the quality of the products. Link to comment Share on other sites More sharing options...
old55pete Posted August 22, 2020 Share Posted August 22, 2020 So far, everything I have gotten from DC was high quality and worked perfect the first time. Link to comment Share on other sites More sharing options...
ratdude747 Posted December 17, 2021 Share Posted December 17, 2021 Late reply, but I'll give my $0.02: Bought door panels from them. Original tooling, which is nice... but there was a lot of difficult to remove (cleanly) mold flash on the panels. Probably due to warpage in the old tooling (I'm not a plastics engineer though, so take that with a grain of salt). I figure 4 stars is appropriate (although if we had halves, I'd make it 4.5). Link to comment Share on other sites More sharing options...
Rembrant Posted December 17, 2021 Share Posted December 17, 2021 I only made one purchase from DC, and that was for a set of NOS Ford Flareside bed sides. They somehow found 20+ sets of these a few years ago, and were selling them for what I thought was an outstanding price, at $149 USD each. I didn't know until then, but they have a separate division called Dennis Carpenter Surplus, as that is where I had to buy the sides from. Same location, but had to talk to a specific guy to get them from their warehouse. They were a great deal for NOS items that nobody else is producing. They were decent to deal with, and the shipping was fair too. Link to comment Share on other sites More sharing options...
salans7 Posted March 20, 2022 Share Posted March 20, 2022 I only made one purchase from DC, and that was for a set of NOS Ford Flareside bed sides. They somehow found 20+ sets of these a few years ago, and were selling them for what I thought was an outstanding price, at $149 USD each. I didn't know until then, but they have a separate division called Dennis Carpenter Surplus, as that is where I had to buy the sides from. Same location, but had to talk to a specific guy to get them from their warehouse. They were a great deal for NOS items that nobody else is producing. They were decent to deal with, and the shipping was fair too. I have no direct dealings with DC, but I have bought parts from NPD that were branded with DC labels. The specific part I purchased is shown below (for 92-96 Fords). I had unfortunately assumed that DC would carry a little higher quality part, and so I thought I would be getting some really good repops, not necessarily made on OE tooling, but almost identical to the factory ones. These were not. They were obviously made overseas and were pretty low quality. I should have realized this by the low price. The letters are lifting underneath the clear overlay, and they don't all line up. I may have gotten a bad batch, but they don't look anything like the OEM ones. DC's website barely shows any info on these, which I guess is a clue. Either way, if it doesn't say it was made by them, you're probably not gonna get anything better than what you'll get with NPD or LMC. Link to comment Share on other sites More sharing options...
Recommended Posts