kramttocs Posted September 30, 2019 Share Posted September 30, 2019 An FYI post... Ready to mount the painted (the ones in photo are spares) rear quarter window trim/frame and wanted to get new nuts for it as the old are all packed with sealant. Found in the doc under exterior trim that the nuts were KZ but to see Exterior Molding Section 'R'. Contacted Gary and he provided:N623421-S Which didn't have any hits but he also found: Nut - Stamped M4 Hex Which was exactly what I needed to find the Disco part number in their catalog. 1040PK. Called up O'Reillys and had a pack of 100 in hand in a couple hours for $8. Thanks Gary! Link to comment Share on other sites More sharing options...
Gary Lewis Posted September 30, 2019 Share Posted September 30, 2019 Welcome! Think you'll have enough? I'll add that Disco # to my master parts catalog for the KZ entries, meaning every place it appears. Assuming of course that they work. Then, as I figure out how to do this those entries will become part of our documentation here. Link to comment Share on other sites More sharing options...
kramttocs Posted October 1, 2019 Author Share Posted October 1, 2019 Welcome! Think you'll have enough? I'll add that Disco # to my master parts catalog for the KZ entries, meaning every place it appears. Assuming of course that they work. Then, as I figure out how to do this those entries will become part of our documentation here. This way if I drop 1...or 80, I will be ok Tested them on my spare trim and they screw on the same as the original so looks like a go. Link to comment Share on other sites More sharing options...
Steve83 Posted October 1, 2019 Share Posted October 1, 2019 ...the old are all packed with sealant.In addition to possibly 1) sealing the holes, that might ALSO be there to 2) prevent the nuts backing off (threadlocker of sorts), and 3) prevent rattles. Link to comment Share on other sites More sharing options...
Recommended Posts