Jump to content
Bullnose Forum

Sun Visor Restoration


Danny G

Recommended Posts

Quick question. I cannot seem to find replacement visor rods. The old gal's springs are old and worn.

I am kind of curious though. Has anyone tried to restore the springs on these?

IMG_20190914_180040.jpg.4a4ce131548f55c180c6101099d65bdc.jpg

I know these are press fit by evidence of the petals here... But what if... You cut the petals off and removed the old spring.

Then tap the outside and put a new spring and lock nut on it.

Or given the clearance in the cab roof, put a piece of all thread in the tube with some epoxy. Then again threaded on a locknut. You should be able to effectively then tension your visors as necessary.

Clips help, I'm thinking a little neodymium magnet at the far end of the visor would hold the visor and keep it from bouncing around.

I see Jeff's Bronco Graveyard has some visor arms but they are listed for 1987+

Link to comment
Share on other sites

The better thing to do is to get the later visors which have the latches on the inside. The outside end will screw right to the existing holes in the trim piece, and you just mark and drill holes for the inside latches.

Believe it or not, do not be surprised if the holes for the inner end are already there. If you can find a set from an XLT Lariat they are dual visors, one swings to the side, the other just folds down in front of the windshield.

Link to comment
Share on other sites

Believe it or not, do not be surprised if the holes for the inner end are already there.

Perhaps on a truck with a headliner. My truck did not come with a headliner, so I had to drill the holes.

The later model, cloth sunvisors were one of the better mods in my interior. No more bouncey visors that keep deploring themselves.....

 

Link to comment
Share on other sites

The better thing to do is to get the later visors which have the latches on the inside. The outside end will screw right to the existing holes in the trim piece, and you just mark and drill holes for the inside latches.

Thing is, I have brand new visors just need the brackets, they are new so I jumped on them when they were in stock as they were OOS for so long. I was today days old when I found out you could use the 87+ sunvisors in the truck.

Will the brackets from the next generation fit these then? It sounds like they mount the same.

Scratch that, answered my own question, they are shorter but good news Jeff's got brackets for $17. going to put an order in.

He does have these retaining anchors.. wonder if they will clip over my visors if I put say a metal clip on the bracket to protect it much like it has on the corners already.

Capture.png.ec21f8c20b4f853e0c6a51cd90efe82e.png

Capture2.png.fb0fc15158dc1c05753fd3b59f964fda.png

 

Link to comment
Share on other sites

×
×
  • Create New...