ArdWrknTrk Posted June 15, 2019 Share Posted June 15, 2019 You’re welcome! Been awhile since I’ve messed with a clutch. But I do remember the cup you’re talking about. Must have done it on the 88 with the 7.3 I used to own. There is a difference, the 4.9, 5.0 and 5.8 are together in the FSM, and the 6.9 and 7.5 are together, but I didn’t look to see the differences. Iirc numberdummy had posted the Windsor slave bracket p/n on FTE, bemoaning the $75 price. So it very well may be the slave bolts to the side of the smaller bell housings. At least it's not one of those concentric slaves like in the 5 speeds! Link to comment Share on other sites More sharing options...
Bulletproof250 Posted June 16, 2019 Author Share Posted June 16, 2019 These are from the 1986 FSM. All in Ft-Lb Flywheel- 75-85 Bell Housing- 40-50 Slave Cylinder- says it’s held in with a C-Clip Clutch, Pressure Plate- 20-29 Transmission- 35-50 Cross Member- 43-57 Driveshaft U-Bolts- Single type- 5/16-18- 8-15 3/8-18- 17-26 7/16-20- 30-40 Tranny to Transfer Case both the BW 1345 and NP 208- 25-43, 1st bolt to tighten is at @ 11:00 looking back at the Transfer Case, then do a cross pattern tightening sequence. All Back together and ready for some clean fuel, and Accel Pump diaphragm. Should be driving this week. Thank to you all in the Bullnose forum! Link to comment Share on other sites More sharing options...
Gary Lewis Posted June 16, 2019 Share Posted June 16, 2019 All Back together and ready for some clean fuel, and Accel Pump diaphragm. Should be driving this week.Thank to you all in the Bullnose forum!Yippee! I'm hearing "On the road again, just can't wait to be on the road again, ...." Link to comment Share on other sites More sharing options...
grumpin Posted June 17, 2019 Share Posted June 17, 2019 Yippee! I'm hearing "On the road again, just can't wait to be on the road again, ....":nabble_smiley_good:Cory said in another post he was just killin time.This killin time is killin me is stuck in my head! Link to comment Share on other sites More sharing options...
Gary Lewis Posted June 17, 2019 Share Posted June 17, 2019 Cory said in another post he was just killin time. This killin time is killin me is stuck in my head! Don't know that I'd ever heard that one before. That's a sad song! Link to comment Share on other sites More sharing options...
grumpin Posted June 17, 2019 Share Posted June 17, 2019 Don't know that I'd ever heard that one before. That's a sad song! Yes it is a sad one by Clint Black. George Jones, If drinkin’ don’t kill me, her memory will! Lots of sad songs, I’m going to cry in my Diet Pepsi! Link to comment Share on other sites More sharing options...
Gary Lewis Posted June 17, 2019 Share Posted June 17, 2019 Yes it is a sad one by Clint Black. George Jones, If drinkin’ don’t kill me, her memory will! Lots of sad songs, I’m going to cry in my Diet Pepsi! I thought those songs were "crying in my beer" songs. Diet Pepsi? That might make it better. Link to comment Share on other sites More sharing options...
Recommended Posts