Gary Lewis Posted April 2, 2019 Share Posted April 2, 2019 Jarek sent me this email, and while I'm going to answer in this thread, I thought it would be better if everyone saw the response in case I'm wrong. Hi Gary, Where could i find info about connecting tachometer in my 1986 f 150? it is Auto Gauge look like VDO tachometer. https://mdcarbon.pl/httpsklepmdcarbonplwskaznik-obrotomierz-auto-gauge-vdo-classic-p-3403html-p-3403.html regards Jarek - I think all tachs have to connect to the "Tach" connection on the coil. But, the tach signal is also in the dash as they did away with the idiot lights for 1986. You can see that wire in the schematics shown here: Electrical/EVTM/1986 EVTM/Start & Ignition. Here's the 1986 5.0L EFI schematic. (Your signature doesn't tell me what fuel system you have, but a 1986 5.0L should be EFI.) You can see the dark green/yellow wire coming off the coil, and going to the tach. So you can use that wire from in the dash, right behind the instruments, to power the tach. Link to comment Share on other sites More sharing options...
Steve83 Posted April 3, 2019 Share Posted April 3, 2019 Yes, since the tachometer was an optional factory gauge, most trucks (that I've messed with) already have the necessary wiring in the instrument cluster connectors. Either drop in a factory tach (my preference, though not necessarily THE factory tach for these old trucks) or splice into those factory wires for an aftermarket tach. Link to comment Share on other sites More sharing options...
jarek_rugby Posted April 3, 2019 Share Posted April 3, 2019 THX :) I will inform when i finish Link to comment Share on other sites More sharing options...
jarek_rugby Posted April 24, 2019 Share Posted April 24, 2019 THX :) I will inform when i finish My tachometer works :) Now i could adjust idle speed Link to comment Share on other sites More sharing options...
Recommended Posts