vicp21 Posted March 12, 2019 Share Posted March 12, 2019 Hi everyone. I did a search for wheels but wasn't having much luck so if it's been covered elsewhere, my apologies. My '82 has the small bolt pattern on the rear and the front was switched to the large pattern by the p/o. I got another large pattern axle for the rear so they match, but now I'm thinking of keeping it because I think this will be a street truck and my '87 will be 4x4. So, my question is-- Will late model mustang wheels fit on the small bolt pattern hubs? I'm sure the rears will clear, but I thought I read that the front hub centers on the trucks are bigger than the cars. I'm thinking mid 2000s Bullit wheels perhaps. If not, can the mustang hubs be swapped over? I don't really want to do a crown vic swap to get the hubs I want. Link to comment Share on other sites More sharing options...
Gary Lewis Posted March 12, 2019 Share Posted March 12, 2019 Jein. (German for "yes and no".) This page gives Mustang bolt patterns, and the one you are looking for is 5 x 4.5", which equates to 5 x 114.3mm, as your truck apparently has the 5 x 4.5" pattern in the back. But, there's a lot more than the bolt spacing to whether a wheel will work. Notice the other columns, like offset and center bore. I don't know offset your truck needs. Nor do I know the center bore of the hubs. Anyway, I do hope that helps? Link to comment Share on other sites More sharing options...
vicp21 Posted March 13, 2019 Author Share Posted March 13, 2019 Jein. (German for "yes and no".) This page gives Mustang bolt patterns, and the one you are looking for is 5 x 4.5", which equates to 5 x 114.3mm, as your truck apparently has the 5 x 4.5" pattern in the back. But, there's a lot more than the bolt spacing to whether a wheel will work. Notice the other columns, like offset and center bore. I don't know offset your truck needs. Nor do I know the center bore of the hubs. Anyway, I do hope that helps? I'm hoping maybe someone has done it before perhaps. It's kind of rare since it's a f100 only issue possibly. I wish I could remember where I saw the mention of the hub. Link to comment Share on other sites More sharing options...
Steve83 Posted March 13, 2019 Share Posted March 13, 2019 I got another large pattern axle for the rear so they match, but now I'm thinking of keeping it because I think this will be a street truck...Regardless, you'll be better-off with the common 5-on-5.5" pattern all around. Mismatching them will make tire rotation almost pointless (side-to-side only). Beyond that, you should also aim for the common '87-96 large pilot (same size as the 4WD front hubs') on the rear axle so the wheels are hubcentric. Link to comment Share on other sites More sharing options...
vicp21 Posted March 13, 2019 Author Share Posted March 13, 2019 I got another large pattern axle for the rear so they match, but now I'm thinking of keeping it because I think this will be a street truck...Regardless, you'll be better-off with the common 5-on-5.5" pattern all around. Mismatching them will make tire rotation almost pointless (side-to-side only). Beyond that, you should also aim for the common '87-96 large pilot (same size as the 4WD front hubs') on the rear axle so the wheels are hubcentric. My goal is to make them match. Currently it's big pattern on the front and small pattern on the rear. Link to comment Share on other sites More sharing options...
Recommended Posts