blackdog Posted April 18, 2019 Author Share Posted April 18, 2019 I must admit I was confused when you said it was melted . .because we are talking about temperatures +/- 2000 degrees . . whereas the case will fall to liquid around 1260. Yeah my bad, something did melt but not case or balls. Link to comment Share on other sites More sharing options...
blackdog Posted April 20, 2019 Author Share Posted April 20, 2019 Yeah my bad, something did melt but not case or balls. Gotta double-check the length of the output shaft, but will be ordering OTC 1130 and OTC 934 puller assembly plus shaft protectors this weekend. If you want it done right gotta do it yourself. One more month of Sundays and i'll have the trans ready. Then its just engine and harness rebuilds for this year. And putting it all together. And troubleshooting. Then some more troubleshooting. Link to comment Share on other sites More sharing options...
Rembrant Posted April 20, 2019 Share Posted April 20, 2019 Gotta double-check the length of the output shaft, but will be ordering OTC 1130 and OTC 934 puller assembly plus shaft protectors this weekend. If you want it done right gotta do it yourself. One more month of Sundays and i'll have the trans ready. Then its just engine and harness rebuilds for this year. And putting it all together. And troubleshooting. Then some more troubleshooting. Sometimes we are forced to do things ourselves huh? Finding competent people is one thing....sometimes finding people at all is a problem...lol. Link to comment Share on other sites More sharing options...
blackdog Posted April 24, 2019 Author Share Posted April 24, 2019 Gotta double-check the length of the output shaft, but will be ordering OTC 1130 and OTC 934 puller assembly plus shaft protectors this weekend. If you want it done right gotta do it yourself. One more month of Sundays and i'll have the trans ready. Then its just engine and harness rebuilds for this year. And putting it all together. And troubleshooting. Then some more troubleshooting. Sometimes we are forced to do things ourselves huh? Finding competent people is one thing....sometimes finding people at all is a problem...lol. pulled the AOD today, and put the exhaust by the curb. I probably could've reused the catalytic converter, but i have nowhere to put it. Has anyone put shorty headers and dual rear-exit exhaust while leaving spare tire carrier as is? time to start diagramming underhood but I can't help thinking ahead. Link to comment Share on other sites More sharing options...
blackdog Posted April 24, 2019 Author Share Posted April 24, 2019 pulled the AOD today, and put the exhaust by the curb. I probably could've reused the catalytic converter, but i have nowhere to put it. Has anyone put shorty headers and dual rear-exit exhaust while leaving spare tire carrier as is? time to start diagramming underhood but I can't help thinking ahead. the headers I look at dont fit injection heads... are all heads for a 5.0 injection heads since they have EFI? Link to comment Share on other sites More sharing options...
Gary Lewis Posted April 25, 2019 Share Posted April 25, 2019 the headers I look at dont fit injection heads... are all heads for a 5.0 injection heads since they have EFI? I've seen dual exhausts with the spare and aux tank in place, so it can be done with factory manifolds. But long-tube headers move the starting point of the exhaust system back quite a ways, and that might make it difficult. As for the heads, I don't think Ford had "fuel injection" heads for the 302. They did for the 460, and they were so different that the intakes and exhausts from a carb'd engine won't bolt up. But I hadn't heard that there were any FI heads for the 302/5.0L. Did I miss something? Link to comment Share on other sites More sharing options...
Recommended Posts