Hey again everyone, I went to replace my valve covers after they have been leaking for a while. And after replacing them they leak really badly out of the passenger side near the firewall. They are new covers and gaskets. Any ideas
can anyone help me identify this seal needed for inside the spindle on the drivers side, noticed the seal was cracking when I was reassembling then lost it over the week. any help would be awesome. I'm thinking its the spindle seal outer
Just wanna again say thank you so much for all your help today, you were a lifesaver got the u joints replaced on both sides, now time for lower ball joints tomorrow, but first a drink tonight while I clean up after my mess
Hey thanks for the help gave it a tough pull and it came right out On Sat, Feb 9, 2019 at 12:47 PM Gary Lewis [via Bullnose Enthusiasts] <redacted_email_address> wrote:
So I can't seem to find the snap ring that you are talking about. is it in the outer groove or is it around the axle shaft itself?
I have installed two of the bolts from the cap in the holes to see if I could pull it out and it maybe moves 1/32 if an inch so something is till holding it in
Sorry for the delay had to run to the parts store before I get snowed in. the pictures I include the first one label current is where the car is right now. the other two are what has been removed so far. and no I never removed another snap ring without tabs on it so ill look for that. Thanks for such quick replies you my friend are a life saver:nabble_anim_jump:
Im From Portland, And I have been struggling to get the rotor off. any help with that would be awesome. even just pointing me in the right direction. I'm new to this whole thing
Hi all, my names James. I live in Oregon and just picked up my first Bronco. Ive lurked on the site for a bit of time so I thought I would make an introduction. planing on replacing my front axle u joints this weekend so if anyone has any info, that would be much appreciated. Will try and get some pics of my rig up later today.