1984 bronco NP 208F output seals

CONTENTS DELETED

You might have better luck posting in the main forum.

Are you looking for the output seals. E0TZ-7B215-B, or the rubber seal washer that goes in under the yoke nut?

The Eotz ones Ard
. I have found them just now on Ebay

So, that's a National 3946, SKF 18992 ?

Or the double lip SKF 18771 ?

Going off the part number from this site they showed up on E Bay and where in Ford boxes. I am going to check the one NAPA sold me for the NP 208 asfar as dimensions but the seals don't look the same.

The NAPA one is an SKF 18992 Jim. I checked this SKF 18992 and the O.D is smaller then the output I.D dimensions

Single lip then....

You might want to check dimensions on the double lip seal.

There must have been a reason for it.

I will Jim. Much appreciated.

The 18771 is 1 7/8 ID 2 3/4 OD and a half inch deep