1984 Bronco front end

I  disassembled the front end of my 84 Bronco last year and now am getting back to re assembly of it. My question is I am looking at the two lower spring seats and noticed they are two different heights, I had these separated driver side and passenger side, unfortunately they have been mixed up since last spring, can anyone help me figure out which one goes where???

I don't know about the heights being different, but if you have a sway bar, the mounts angle outwards. If no one else responds, I'll try to look at my 4x4 at lunch and let you know.

Passenger side is about a 1/4" thicker. You would never notice when they're installed in the truck, but if you have them side by side on the bench it is noticeable. People mix them up every now and then and end up with a lopsided truck. Below is a picture of a set of seats out of a 4x4 Bricknose when the swaybar mounts were integrated with the seats. The Bullnose seats are the same, they just don't have swaybar mounts.

I forgot that I had a Bullnose set here. These are from a 1984 F150 2wd.